When should a pre-applied HDPE membrane be installed?
The membrane is generally installed before reinforcement placement and concrete pouring, in accordance with the approved installation method statement. The substrate should be prepared, membrane laid, overlaps and detailing completed, and the installation inspected before subsequent construction activities proceed.

Does the substrate require preparation before installing the membrane?
Yes. The substrate must be suitable for the selected membrane system. It should be sufficiently stable and free from conditions that could compromise membrane installation, including sharp protrusions, unsuitable debris or irregularities beyond the system’s permitted limits. The manufacturer’s installation instructions should be followed.

How are membrane overlaps treated?
Membrane overlaps are treated according to the manufacturer’s prescribed installation procedure. The overlap width, joint preparation and joining method must be specified for the particular membrane system. The installer should not assume that all HDPE membranes use the same overlap or jointing method.

How are corners and wall-to-slab junctions waterproofed?
Corners and wall-to-slab junctions require careful detailing because they involve changes in geometry and often form critical areas in waterproofing systems. Appropriate membrane detailing, additional components where specified and careful installation are required to maintain waterproofing continuity. Typical corner and junction details should be followed from the approved drawings and method statement.

How are pipe penetrations treated in pre-applied waterproofing systems?
Pipe penetrations require special attention because they interrupt the continuity of the membrane. Penetration details should use compatible sealing and membrane detailing components appropriate to the system. The detail should be designed and installed to maintain waterproofing continuity around the penetration.

How are construction joints treated?
Construction joints are important locations in structural construction and waterproofing. The waterproofing system should be coordinated with the structural joint design and the specified joint treatment components. Membrane continuity, detailing and installation at these locations should follow approved project drawings.

How is the membrane protected during reinforcement placement?
The membrane should be protected against damage from reinforcement, equipment, foot traffic and subsequent construction activities. Reinforcement placement should be carried out carefully, avoiding dragging, puncturing or unnecessary impact on the installed membrane. The manufacturer’s protection and inspection procedures should be followed.

Can the waterproofing membrane be installed in rainy weather?
Installation conditions depend on the specific membrane system and the manufacturer’s requirements. The substrate, installation surfaces, jointing procedures and weather conditions should comply with the approved method statement. Site conditions should be assessed before installation proceeds.

What happens if the membrane is damaged before concrete placement?
Any damage should be inspected and repaired using the manufacturer’s approved repair procedure and compatible materials. Repairs should be completed and inspected before reinforcement placement or concrete pouring proceeds.

How should membrane installation be inspected before concrete placement?
A pre-concrete inspection should verify:
• Membrane continuity.
• Correct orientation and installation.
• Overlap and joint treatment.
• Corner and junction detailing.
• Penetration treatment.
• Repairs to any damaged areas.
• Compliance with the approved installation drawings.
• Protection against subsequent construction activities.
An inspection checklist helps establish a systematic quality-control process.
D. Applications & Construction Details